SVL Extension: Pre-Wiring

I did a little work on the extension this weekend. Before I lay the foam on top of the benchwork, I decided that now would be a good time to run bus wires for the track wiring.

I drilled two holes in each cross piece approximately where the mainline will run. Then, I ran two wires, one through each hole. These are 14ga ROMEX wires used for house wiring. I stripped off the plastic covering and ran a white and black wire around the entire extension. I will tie the ends of these wires into the existing track bus later.

You will also noticed that I primed the backdrop.

Sorry if these pictures are a little fuzzy.





Next, I will start laying foam.